Setting Up The Live Mode - Toguard H40 Trail Camera Manual De Instrucciones

6.2 Setting Up The Live Mode

EN
The standard application of the Wildlife Camera is the Live mode.
In this mode , photos are either triggered by movement sensors or at
intervals according to the respective setting.
To set up the Live mode , switch mode switch to ON position. The red
LED will flash for 15 times when you just switch to Live mode (ON),
and then the camera work automatically and enters the Standby mode.
As soon as wild animals or other objects directly enter the detection area of
the sensor zone, the camera starts to record photos and videos.
Note:
In the daytime. IR LEDs will not light up. The photos and videos are in color.
At night. IR LEDs will give lights, and the photos and videos are in black and
white.
The Shot lag is 1 minute defaulted. The optional is 5s-60 MIN,
Please set up recording mode and related parameters before entering Live
mode.
When Flash Light is set to "Auto", the camera will adjust the brightness of IR
LEDs automatically in low power. When shooting at night, the brightness will
decrease automatically, and the shooting effect will become a little poor. For
ultra low power, shooting will stop at night.
15