Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
9.
To test if the line is advancing properly, push the but-
ton with your thumb while pulling the line with your fin-
gers. The line should advance freely. (Fig. 30).
10. In the event of the line breaking inside the spool,
repeat the replacement operation.
11. Start the grass trimmer following the instructions in
the "STARTING" section.
Input . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .120V~, 60Hz, 4 Amp
No Load Speed . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7,500/min.
Cutting Width . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .13" (330mm)
Line Diameter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .ø0.065" (1.65mm)
Net Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6.4 Lbs (2.9 Kg)
MAINTENANCE INSTRUCTIONS
Fig. 30
SPECIFICATION
MAINTENANCE
CAUTION:
operations, cut off the electric power supply by
disconnecting the plug from the extension
cord.
1.
Regular cleaning and maintenance of your string trim-
mer will ensure efficiency and prolong the life of your
machine.
2.
After each cutting operation, take apart and clean out
the grass and soil from: the spool and its slot and in
particular the debris shield.
3.
During operation, keep the air slots clean and free of
grass.
4.
Only use a cloth soaked with hot water and a soft
brush to clean the string trimmer.
5.
Do not spray or wet the appliance with water.
6.
Do not use detergents or solvents as these could ruin
the trimmer. The parts made of plastic can easily be
damaged by chemical agents.
7.
If the line cutting blade no longer cuts or breaks, have
this replaced by contacting an authorized
center.
13
Before carrying out
any maintenance
service
Publicidad
Capítulos
Tabla de contenido
