NuTone CFC56BR Manual De Instrucciones página 3

INSTALL THE FAN
1. Pass the 120-volt supply wires through the center hole in the ceiling
hanger bracket as shown in Fig. 5.
2. Secure the mounting bracket to the ceiling outlet box with the screws
and washers provided with your outlet box.
3. Remove the hanger pin, locking pin and set screws from the top of
the motor assembly.
4. Route wires exiting from the top of the fan motor through the lower
canopy, canopy cover and canopy, then through the ball / downrod.
(Fig. 6)
5. Align the holes at the bottom of the downrod with the holes in the
collar on top of the motor housing (Fig.6). Carefully insert the hanger
pin through the holes in the collar and downrod. Be careful not to
jam the pin against the wiring inside the downrod. Insert the locking
pin through the hole near the end of the hanger pin until it snaps
into its locked position, as noted in the circle inset of Fig. 6.
6. Tighten two set screws on top of the fan motor firmly. (Fig. 6)
7. Slide lower canopy down on top of the motor housing. Tighten lower
canopy screw. (Fig. 6)
8. Place the downrod ball into the hanger bracket socket. Line up
registration slot on ball with hook on mounting plate. (Fig. 7)
MODELS CFC56BR • CFC56WH
CUL LISTED
ELECTRIAL
BOX
MOUNTING
BRACKET
120V WIRES
FIGURE 5
DOWNROD
LOWER
CANOPY
HANGER PIN
FIGURE 6
REGISTRATION
SLOT
FIGURE 7
Page 3
WASHERS
MOUNTING SCREWS
(SUPPLIED WITH
ELECTRICAL BOX)
CANOPY
LOWER CANOPY
SCREW
SET SCREWS
LOCKING
PIN
HOOK