Mounting Options - NuTone CFC56BR Manual De Instrucciones

CONTENTS
Unpack your fan and
check the contents.
You should have the
following items:
A - Blade Set (3)
B - Mounting Bracket
C - Upper Canopy
D - Downrod
E - Lower Canopy
F - Fan Motor
Assembly
G - Hardware
Package
(Note: Package
may contain extra
hardware.)
TOOLS & MATERIALS
REQUIRED
FLAT
PHILLIPS BLADE
SCREW
SCREW
DRIVER DRIVER

MOUNTING OPTIONS

If there isn't an existing UL listed mounting box, then read the following
instructions. Disconnect the power by removing fuses or turning off
circuit breakers.
Secure the outlet box directly to the building structure. Use appropriate
fasteners and building materials. The outlet box and its support must be
able to fully support the moving weight of the fan (at least 50 lbs). Do
not use plastic outlet boxes.
Figures 1,2 and 3 are examples of different ways to mount the outlet box.
Note: You may need a longer downrod to maintain proper blade clearance
when installing on a steep, sloped ceiling. (Fig. 3)
To hang your fan where there is an existing fixture but no ceiling joist,
you may need an installation hanger bar as shown in Figure 4.
B
C
A
D
E
F
STEP WIRE
LADDER CUTTER
G
RECESSED
OUTLET BOX
MODELS CFC56BR • CFC56WH
OUTLET BOX
FIGURE 1
OUTLET BOX
FIGURE 2
PROVIDE STRONG
SUPPORT
FIGURE 3
OUTLET BOX
FIGURE 4
Page 2
CEILING
MOUNTING
PLATE