Faucet Installation - Black and Decker Price Pfister Skye 46 Serie Manual Del Usuario

Thank you for purchasing this Price Pfister product. All Price Pfister products are carefully engineered, and factory tested to
provide long trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow
illustrated instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding. Price Pfister
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
2
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually found
under the sink or near the water meter. If you are replacing an existing faucet, remove
the old faucet from the sink and clean the sink surface thoroughly.
3
3 TOOLS RECOMMENDED
• PTFE Plumber's Tape • Plumber's putty
• Adjustable wrench • Pliers
• Cloth
Your installation may require new supply lines and / or shut-off valves or other additional
tools.
This product comes with an installation tool used for securing the handle flange and a
Hex Wrench for tightening a Set Screw into the Handle Levers.

FAUCET INSTALLATION

Your faucet can be installed with or without the deck plate:
For installation using the deck plate:
For installation without using the deck plate:
• Slotted screwdriver
• Flashlight
Go To Step 4
Go To Step 7
ENGLISH
INSTALLATION USING DECK PLATE
4
BOTTOM GROOVE
4 DECK PLATE INSTALLATION
(For installation without the deck plate, go to step 7.)
Ensure that the Plastic Putty Plate (4A) is pressed on the Deck Plate (4B). Place a bead
of plumber's putty in the groove along the edge of the Putty Plate (4A). Install the Deck
Plate (4B) over the three holes in your sink.
5
5D
5C
5 SPOUT INSTALLATION
Insert Spout Shank (5A) through the center hole. From underneath sink, place Thrust
Washer (5B) onto Spout Shank (5A) and tighten with Mounting Nut (5C). Before final
tightening, be sure Spout (5D) is centered and facing forward.
Caution: Do not over tighten!
2
4A
5A
5B
4B