Zoeller APak 10-4011-A Instrucciones De Instalación página 4

Power LED
Input 1 Alarm
LED and Alarm
Low Battery Alarm
Behaviors
Power Out Alarm
Press/Release
Hold 3 Seconds
Silence Button
Hold 4 Seconds
Hold 12 Seconds
Battery Life
Battery Life
APAK LED, BUTTON, AND ALARM BEHAVIORS
®
AC and DC Mode
Power LED is on when AC and DC
power are present.
Input LED on solid.
Alarm triple beeps continuously.
Power LED blinks.
Alarm triple beeps every 5 seconds.
All LEDs go out to conserve battery
power.
Power LED blinks and alarm double
beeps every 30 seconds.
Silences Alarms. LED that is in
alarm stays on (or blinks) until
APak is Reset.
®
Resets any active alarms and
returns APak to standby mode.
®
Initiates a LED and Alarm Test. Will
flash and double beep 3 times.
Complete reset of APak
settings.
1-2 years with normal use.
© Copyright 2021 Zoeller
AC Only Mode
Power LED is on when AC power
is present.
Input LED on solid.
Alarm triple beeps continuously.
N/A
N/A
Silences Alarms. LED that is in
alarm stays on (or blinks) until
APak is Reset.
®
Resets any active alarms and
returns APak to standby mode.
®
Initiates a LED and Alarm Test. Will
flash and double beep 3 times.
to factory Complete reset of APak
®
settings.
N/A
Co. All rights reserved.
®
DC Only Mode
Power LED off when only batteries
have been inserted, but will blink
when button pressed.
Input LED blinks and alarm double
beep every 5 seconds.
Power LED blinks and alarm beeps
every 10 seconds.
N/A
Silences alarm. LED still blinks
every 5 seconds until alarm is
Reset. In standby mode, a short
beep will occur to indicate APak
is ready.
Resets any active alarms and
returns APak to standby mode.
®
Initiates a LED and Alarm Test. Will
flash and double beep 3 times.
to factory Complete reset of APak
®
settings.
Approximately 1 year with normal
use.
®
to factory
®