Fcc Statement - DSC HSM2955 Guia De Inicio Rapido

IN ANY EVENT, IF ANY STATUTE IMPLIES WARRANTIES OR CONDITIONS NOT
STATED IN THIS LICENSE AGREEMENT, DSC'S ENTIRE LIABILITY UNDER ANY
PROVISION OF THIS LICENSE AGREEMENT SHALL BE LIMITED TO THE
GREATER OF THE AMOUNT ACTUALLY PAID BY YOU TO LICENSE THE
SOFTWARE PRODUCT AND FIVE CANADIAN DOLLARS (CAD$5.00). BECAUSE
SOME JURISDICTIONS DO NOT ALLOW THE EXCLUSION OR LIMITATION OF
LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES, THE ABOVE
LIMITATION MAY NOT APPLY TO YOU.
(d) DISCLAIMER OF WARRANTIES
THIS WARRANTY CONTAINS THE ENTIRE WARRANTY AND SHALLBE IN LIEU
OF ANY AND ALLOTHER WARRANTIES, WHETHER EXPRESSED OR IMPLIED
(INCLUDING ALL IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE) AND OF ALL OTHER OBLIGATIONS OR
LIABILITIES ON THE PART OF DSC. DSC MAKES NO OTHER WARRANTIES.
DSC NEITHER ASSUMES NOR AUTHORIZES ANY OTHER PERSON
PURPORTING TO ACT ON ITS BEHALF TO MODIFY OR TO CHANGE THIS
WARRANTY, NOR TO ASSUME FOR IT ANY OTHER WARRANTY OR LIABILITY
CONCERNING THIS SOFTWARE PRODUCT.
(e) EXCLUSIVE REMEDY AND LIMITATION OF WARRANTY
UNDER NO CIRCUMSTANCES SHALL DSC BE LIABLE FOR ANY SPECIAL,
INCIDENTAL, CONSEQUENTIAL OR INDIRECT DAMAGES BASED UPON
BREACH OF WARRANTY, BREACH OF CONTRACT, NEGLIGENCE, STRICT
LIABILITY, OR ANY OTHER LEGAL THEORY. SUCH DAMAGES INCLUDE, BUT
ARE NOT LIMITED TO, LOSS OF PROFITS, LOSS OF THE SOFTWARE
PRODUCT OR ANY ASSOCIATED EQUIPMENT, COST OF CAPITAL, COST OF
SUBSTITUTE OR REPLACEMENT EQUIPMENT, FACILITIES OR SERVICES,
DOWN TIME, PURCHASERS TIME, THE CLAIMS OaF THIRD PARTIES,
INCLUDING CUSTOMERS, AND INJURY TO PROPERTY.
WARNING: DSC recommends that theentiresystembecompletely testedonaregular basis.
However, despitefrequent testing, anddueto, but not limitedto, criminaltamperingor electrical
disruption, it is possiblefor this SOFTWARE PRODUCT tofailtoperformas expected.

FCC STATEMENT

CAUTION: Changes or modifications not expressly approved by Digital Security Controls
couldvoidyour authority tousethis equipment.
This equipment has been testedandfound tocomply withthe limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable pro-
tectionagainst harmful interferenceina residentialinstallation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference toradio communications. However, there is no
guaranteethat interferencewillnot occur in aparticular installation. If this equipment does cause
harmfulinterferencetoradioor televisionreception, whichcanbedeterminedby turningtheequip-
ment off andon, theuser is encouragedtotry tocorrect theinterferenceby oneor moreof thefol-
lowingmeasures:
- Re-orient thereceivingantenna.
- Increasetheseparationbetweentheequipment andreceiver.
- Connect theequipment intoanoutlet onacircuit different fromthat towhichthereceiver is con-
nected.
- Consult dealer or experiencedradio/televisiontechnicianfor help.
The user may find the following booklet prepared by the FCC useful: 'How to Identify and
Resolve Radio/Television Interference Problems'. This booklet is available from the U.S.
Government PrintingOffice, WashingtonD.C. 20402, Stock #004-000-00345-4.
IMPORTANT INFORMATION
This equipment complies withPart 68of theFCC Rules and therequirements adoptedby the
ACTA. Onthesideof this equipment is alabelthat contains, amongother information, a product
identifier intheformat US:AAAEQ##TXXXX. If requested, this number must beprovidedtothe
TelephoneCompany.
Product identifier: US: F53MO01BHSM2955
USOC Jack: RJ-31X
TelephoneConnectionRequirements
A plug and jack used to connect this equipment tothe premises wiringand telephone network
must comply withthe applicableFCC Part 68 rules andrequirements adopted by theACTA. A
compliant telephonecordandmodular plug is providedwiththis product. It is designedtobe con-
nected to a compatible modular jack that is also compliant. See installation instructions for
details.
Ringer EquivalenceNumber (REN)
TheREN is usedtodeterminethenumber of devices that may beconnectedtoatelephone line.
ExcessiveRENs onatelephonelinemay result inthedevices not ringinginresponsetoanincom-
ingcall. Inmost but not allareas, thesum of RENs shouldnot exceedfive(5.0). Tobecertain of
thenumber of devices that may beconnected toa line, as determined by the totalRENs, con-
tact thelocalTelephoneCompany. For products approved after July 23, 2001, theREN for this
product is part of theproduct identifier that has theformat
US: AAAEQ##TXXXX. The digits represented by ## are the REN without a decimal point
(e.g., 03is aREN of 0.3). For earlier products, theREN is separately shownonthelabel.
Incidenceof Harm
If this equipment HSM2955causes harmtothetelephone network, thetelephonecompany will
notify youin advancethat temporary discontinuanceof service may berequired. But if advance
noticeis not practical, the Telephone Company willnotify the customer as soon as possible.
Hereby, DSC, declares that this device is in compliance with the essential requirements and other
relevant provisions of Directive 1999/5/EC. The complete R&TTE Declaration of Conformity can
be found at: http://www.dsc.com/listings_index.aspx.
© 2015 Tyco Security Products. All Rights Reserved.
Toronto, Canada • www.dsc.com
Tech Support: 1-800-387-3630 (Canada & U.S.) or 905-760-3000
Also, youwill beadvised of your right tofile acomplaint with theFCC if youbelieve it is neces-
sary.
Changes inTelephoneCompany Equipment or Facilities
The Telephone Company may make changes in its facilities, equipment, operations or pro-
cedures that couldaffect theoperation of theequipment. If this happens the Telephone Com-
pany will provide advancenotice in order for you to makenecessary modifications to maintain
uninterruptedservice.
Equipment MaintenanceFacility
If troubleis experiencedwith this equipment HSM2955, contact thefacility indicatedbelow for
repair or warranty information. If the equipment is causingharm tothe telephonenetwork, the
TelephoneCompany may request that youdisconnect theequipment untiltheproblemis solved.
This equipment is of a type that is not intendedto be repairedby the enduser. DSC c/o APL
Logistics, 757Douglas HillRd., LithiaSprings, GA30122, USA
AdditionalInformation
Connectionto party line serviceis subject to statetariffs. Contact the statepublic utility com-
mission, public servicecommissionor corporationcommissionfor information.
Alarmdialingequipment must be abletoseizethe telephonelineandplace acallinan emergency
situation. It must beabletodothis evenif other equipment (telephone, answeringsystem, com-
puter modem, etc.) already has thetelephoneline inuse. Todoso, alarmdialingequipment must
beconnectedtoaproperly installedRJ-31X jack that is electrically inseries withandaheadof all
other equipment attached tothesame telephoneline. Proper installationis depicted inthe figure
below. If you have any questions concerning these instructions, you should consult your tele-
phonecompany or aqualified installer about installing the RJ-31X jack and alarm dialing equip-
ment for you.
IC: 160A -HSM2955
CAN ICES-3(B)/NMB-3(B)
NOTICE: This equipment meets the applicableIndustry Canada Terminal Equipment Tech-
nicalSpecifications. This is confirmed by theregistration number. The abbreviation, IC, before
theregistrationnumber signifies that registrationwas performedbasedonaDeclarationof Con-
formity indicatingthat Industry Canadatechnicalspecifications weremet. It does not imply that
Industry Canadaapprovedtheequipment.
NOTICE: The Ringer Equivalence Number (REN) for this terminal equipment is 0.1. The
REN assignedtoeachterminalequipment provides anindicationof themaximumnumber of ter-
minals allowedtobeconnectedtoatelephoneinterface. Theterminationonaninterfacemay con-
sist of any combination of devices subject only tothe requirement that thesum of the Ringer
EquivalenceNumbers of allthedevices does not exceed5.
AVIS: Leprésent matérielest conformeaux spécifications techniques d'IndustrieCanadaapplic-
ables au matérielterminal. Cetteconformité est confirmée par le numérod'enregistrement. Le
sigleIC, placé devant le numéro d'enregistrement, signifieque l'enregistrement s'est effectué
conformément àune déclarationdeconformité et indiqueque les spécifications techniques d'In-
dustrieCanadaont étérespectées. Iln'impliquepas qu'IndustrieCanadaaapprouvélematériel.
AVIS : L'indiced'équivalencedelasonnerie(IES) duprésent matérielest de0.1. L'IES assigné à
chaquedispositif terminal indiquelenombre maximalde terminaux quipeuvent êtreraccordés à
uneinterface téléphonique. La terminaison d'une interface peut consister en une combinaison
quelconquededispositifs, àlaseuleconditionquelasommed'indices d'équivalencedela sonnerie
detous les dispositifs n'excèdepas 5.
2 9 0 0 8 4 3 4 R0 0 1