LUND 318089 Instrucciones De Instalación

For technical assistance or to obtain missing parts, please call Customer Relations at 1-800-241-7219.
Important Safety Information
• To be used with Lund® branded products only.
• Do not stand on Lund running board or bracket while vehicle is in motion.
• Do not use the brackets as a jacking point for the vehicle.
• Do not use the bracket system or running boards to fasten cargo.
• Periodically check all components for tightness.
• Be sure to wear safety glasses while installing brackets.
•When using power tools, read and understand all operating instructions.
Contents
NOTE: Actual product may vary from illustration.
Driver Side Front
Bracket x1
8mm Bolt Plate x4
5/16" Flange Nut
(black colored) x18
(silver colored) x8
Tools Required
Ratchet and Extension 13mm Socket
Preparation Before Installation
• Park your vehicle in a clean, level location. Check to make sure the vehicle is in park, or for manual drive models, place the
transmission in first gear. Engage the parking brake. Chock wheels.
• Unpack the bracket kit and identify the parts according to the content descriptions.
• Air tools recommended.
Installation Instructions
Running Board Bracket Kit
For proper installation and best possible fit, please read all instructions BEFORE you begin.
Passenger Side Front
Bracket x1
8mm Offset Bolt Plate x2
8mm Flange Nut 10mm Flange Nut
(black colored) x2
14mm Socket
Driver Side Rear Passenger Side Rear
Bracket x1
10mm Large Offset Bolt Plastic Retainer
Plate x2 (small hole) x6
8mm Flange Bolt x12
13mm Wrench
Page 1 of 5
I - Sheet Number 10756 Rev.A
LUND Part#318089
End Plate
Bracket x1 Bracket x4
Plastic Retainer
(large hole) x2
Wheel Chocks Safety Glasses