Cudy 24GE(PoE)+2G Combo+2GE Guía Del Usario página 9

LED indicator
LED
PWR
LNK/ACT
PoE
DIP Switch
The DIP switch located on the left panel.
Default: the factory default mode, can normal communication between port 1~28.
VLAN: 1-24 port can be isolated each other but 1-24 port can connect to 25 ~28 port after open VLAN to stop broadcast
storm to increase forwarding rate of frame.
CCTV: Up to 250m PoE distance allows you to expand you network via Ethernet cable but where you want to fix device
such as IP Cameras.
Note: After change the mode, in order to the corresponding configuration take effect. The switch needs to restart
manually.
Rear Panel
The rear panel of 24GE(PoE)+2G Combo+2GE PoE Switch indicates an AC inlet power socket, Grounding Column.
Color Function
Off: No Power supply
Green
Light: Indicates the switch has power
Off: No device is connected to the corresponding port
Light: Indicates the link through that port is successfully
Green established at 1000Mbps.
Blink: Indicates that the Switch is actively sending or
receiving data over that port.
Off: No device is connected to the corresponding port
Light: Indicates the link through that port is successfully
Orange
established at 10/100Mbps.
Blink: Indicates that the Switch is actively sending or
receiving data over that port.
Off: No PoE powered device (PD) connected
Light: There is a PoE PD connected to be port, which
Orange
supply power successfully.
Blink: Indicates port abnormal power supply
- 2 -