SPIKES-SPIDER EASY Sport Instrucciones página 31

GB
Distance indicator
Step 2 (determine the appropriate size of the clamp for the nut)
From the vehicle table, determine which size of the three different included "Fix-Clip" clamps you need for your nuts (17 mm, 19 mm or 21 mm).
(22 mm and 24 mm Fix Clip and additional distance parts can be ordered separately.)
Step 3 (Mounting the clamps and the hexagonal distance parts on the rim)
In the case of rims with 4 and 6 holes, the „Fix-Clip" clamps and the hexagonal distance parts are mounted on two opposite wheel screws/nuts, in the case
of 5-hole rims, on wheel screws/nuts that are two apart.
Now, screw the first of the hexagonal distance screws (B1, B2 or C+D) determined, by hand, onto the two caps (A2) and the 3-armed clamp (A1), and place
these, screwed together, onto the wheel screw/nut (see illustration 2). To fasten, place the included pipe wrench (H) onto the pre-mounted hexagonal
distance screw. Place the short end of the torque stick (I) into the lateral opening provided in the pipe wrench. Hold on to the pipe wrench slightly over the
screw, to avoid it from skidding and to avoid adjusting it obliquely (see Illustration).
Now, using the torque stick, tighten the corresponding hexagonal distance screw. Note: the screws are only tightened correctly, if the eyelet of the torque
stick moves noticeably (see Illustration 3).
Then turn the additional distance screws (B 2 and/or C+D) onto the preassembled distance screws on the rim individually until they stop, and then pull them
tight with the pipe wrench (H) and the torsion bar (I). For the distance options 2, 3, and 4, screw the screws (C+D) into the last distance screws (B1 or B2).
(see illustration 4)
Only use the included tools for assembly!
1 3
2
4