Broiler Pan And Grid; Lift-Off Oven Door - Danby Designer DR201WGLP Guía De Utilización Y Cuidado Para El Propietario

BROILER PAN AND GRID

LIFT-OFF OVEN DOOR

Slot
Slot
Hinge
Hinge
lock
lock
Upper hinge
Upper hinge
arm
arm
TO CLEAN THE DOOR:
To clean the inside of the door:
• Do not allow excess water to run into any holes or slots in the door.
• Wipe dishwashing detergent oven any baked-on spatters on the glass. Use a single sided safety razor blade to clean
it off. Then wipe over the glass with a soapy cloth to remove any residue and dry off.
• The area outside the gasket can be cleaned with a soap-fi lled plastic scouring pad.
To clean the outside of the door:
• Use soap and water to thoroughly clean the top, sides and front of the oven door. Rinse well. You may also use a
glass cleaner to clean the glass on the outside of the door.
• Spillage of marinades, fruit juices, tomato sauces and basting materials containing acids may cause discoloration and
should be wiped up immediately. When the surface is cool, clean and rinse.
• Do not use oven cleaners, cleansing powders or harsh abrasives on the outside of the door.
CARE AND MAINTENANCE
• After broiling, remove the broiler pan from the oven. Remove the grid from the pan.
Carefully pour out grease from the pan into a proper container. Wash and rinse the
broiler pan and grid in hot water with a soap-fi lled or plastic scouring pad.
• If food has burned on, sprinkle the grid with detergent while hot and cover with wet paper
towels or a dishcloth. Soaking the pan will remove burned on foods.
• Do not store a soiled broiler pan and grid anywhere in the range.
The oven door is removable, but it is heavy. You may need help removing and
replacing the door.
To remove the door:
1. Open the door to the full open position.
2. Pull the hinge locks up over the hinge hooks on both sides. You may need
to use a fl at-blade screwdriver to lift hinge locks up.
3. Grasp the door fi rmly on each side, lift slightly and pull it straight out and
away from the oven.
To replace the door:
Lower hinge
Lower hinge
1. Firmly grasp both sides of the door at the top.
arm
arm
2. Insert and seat the upper and lower hinge arms into the oven slots.
3. Push the hinge locks down from the hinge hooks.
4. Close the oven door and make sure it is working properly. If it is not
working properly, remove and replace it following the above steps.
DO NOT ATTEMPT TO CLOSE THE DOOR UNTIL THIS STEP IS
COMPLETE. THE HINGE OR DOOR COULD BE DAMAGED.
• The gasket is designed with a gap at the bottom to allow for proper air circulation.
• Do not rub or clean the door gasket - it has an extremely low resistance to abrasion.
• If you notice the gasket becoming worn, frayed or damaged in any way or if it has be-
come displaced on the door, you should have it replaced.
18