Publicidad
Idiomas disponibles
Idiomas disponibles
English
Remote Control Functions (Fig.1)
Delay - Off
Blower Speed Decrease and Off
Blower Speed Increase and On
Light
Press
(Delay) and
Reset Filter Alarm.
CAUTION RISK OF EXPLOSION IF BATTERY IS
REPLACED BY AN INCORRECT TYPE. DISPOSE
OF USED BATTERY IN ACCORDANCE WITH
LOCAL REGULATIONS.
FCC ID: QUS-BESMARTNEW
IC: 11613A-BESMARTNEW
• Changes or modifications not expressly approved
by the party responsible for compliance could void
the user's authority to operate the equipment.
• This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
• This device complies with Industry Canada license-
exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not
cause interference, and (2) this device must accept
any interference, including interference that may
cause undesired operation of the device.
INDICATOR
LIGHT
FIG. 1
(Light) buttons together to
LINKING PROCEDURE
- The remote must be linked to the range hood in order to work
properly.
- This procedure is also useful if there are two or more products
that can be controlled by means of remote control. For
example, in apartments with adjacent kitchens, showrooms,
fairs, etc.
- If the remote is included with the range hood, this linking
procedure will have already been completed at the factory.
1 -
Determine the hood control from list below.
2 -
Press
and
buttons on the remote simultaneaously
for 5 seconds, until the remote control Indicator Light turns
on. Release
and
button to confirm the linking. At this point the remote
control Indicator Light starts flashing to confirm the link
is active.
3 -
Within 3 seconds press and release the Link Confirm
button on the hood control (see below).
HOOD CONTROLS
Hood Control 1
LINK CONFIRM BUTTON - P1
Hood Control 2
LINK CONFIRM BUTTON - P5
Hood Control 3
LINK CONFIRM BUTTON - P2
Hood Control 4
LINK CONFIRM BUTTON - P1
Hood Control 5
LINK CONFIRM BUTTON - P3
Hood Control 6
LINK CONFIRM BUTTON - A
Note: To complete link, press and hold "link confirm
button A" until hood user interface light intensity
indicator 1 and 3 flash 3 times.
S
PEED
1
2
3
4
A
B
buttons. Press and release
L
IGHTING INTENSITY
1
2
C
D
E
3
Publicidad
