Triton Blue T300-3200-2550 Manual De Usuario página 10

USAGES AND OPERATIONS
1. Set the address of DMX512
When using a DMX512 console to control the light, the light should be set up the address, ranging
from 1- 512. Press up / down button of Address, current state will be set to be controlled by
DMX512 signal control mode. Press the up / down button once, address will be add / subtract
once; when press up / down button longer, the address will fast continuous add and subtract.
Note: The address will be reserved automatically after operation stop for 10 seconds.
2. Manual host 16 bit dimming mode.
DMX512 console is not needed in this mode, but the light is set to be the host (console). It will
send DMX512 signal to control the lights connected with signal wire of same series, which makes
these light change the brightness accordant to the host. When using this function, one should pay
special attention to that no console's signal connect, or there would be interference. Press the up /
down button of Dimmer, the current state is set to manual mode of host, 16- bit dimming mode.
single-press the up / down buttons, the brightness will be up / down once; when press up / down
button longer, the brightness will fast and continuously add and subtract ranging from 0- 65535.
Note: This state will be saved automatically after stop operating for 10 seconds.
3. Manual test 16 bit dimming mode
The function of this mode is to test whether one single
light can be operated normally, it will not send DMX512
signal to influence the lights that connected with it. Press
up and down of Address at the same time, press up/ down
of Dimmer to dim,
brightness value when dimming, ranging from 0 to 65535.
Note: This state will not be reserved.
4. When the light is in the received state
receive signal or can't connect the signal wire, the backlight
of the liquid crystal display will flash, from which we can
know that if the connect wire is connected successfully.
5. Adjust the spot
Pull out four lighting adjusted slice
the power and control lighting. Adjust two focusing knob
can adjust the spot to different diameter. Tighten the
focusing knob (3) when you get the diameter you need and
the spot is clear.
6. Gobo
If you want to print some picture, firstly you should choose
the gobo holder of our company (the maximize range the
picture should beφ64. 5mm, outside diameter φ86mm). The
displayed picture is reversed. Put the gobo into gobo holder,
and then put it into the gobo notch (2). Lighten the light
and adjust the position of the focusing knob (3), image of
different diameter will display. Tighten the focusing knob
when you get the diameter you need and the spot is clear.
10.
will display, XXXXX is the
, it can't
(1) completely, connect
(3)
User manual | T300-3200-2550 Triton Blue | October 2018 | www.triton-blue.com
7. Spot cutting
The spot of different shape will display when adjusting four
lighting adjusted slice (1). If you have special need, you can
unscrew the front device (4). The image can incline 45° by
turning the front device (5).
8 . Iris
If more spot of different diameter are needed, you can choose
our company's iris. Loose the screw of the door
of the light, move forward to expose the bayonet, put the iris
inside, adjust the size of the iris, different size spot will display.
9 . Color film
If you need color rendering, clip the color paper with color
clamp, open the position (7) and put the color clamp in it. Or you
can use our company's color change frame for profile spotlight,
controlled by DMX512 signal, CMY colors blending for more
brilliant color.
(6) on the top