JUST ONE HELMET J12 Instrucciones De Uso página 29

INTERNAL CENTRAL PADDING:
(fitting and removal)
REMOVAL see fig. 5A
The internal padding is fixed to the helmet through 3 tongues on the back and a crown with
some bottom and some little tongues on the front that fix the internal padding to the poly-
styrene.Remove the removable cheek pads (refer to paragraph CHEEK PADS). Release the
back stud buttons and release in the front part of the polystyrene, the click-in tongue from its
seats. Slide out the two side tongues that fix the internal padding to the polystyrene. Remove
the internal padding.
Caution: to avoid damaging the internal lining, before removing the padding, make
sure the tow back stud buttons were released.
FITTING see fig. 5.B - 5C
Position the internal padding of the helmet checking the direction of assembly. Fix the front
tongue to its support on the polystyrene, fasten the back stud buttons and reinsert the side
tongues between the shell and the polystyrene.
After fitting the parts, make sure the internal padding was positioned correctly.
If these conditions are not verified and the internal padding was not fitted correctly, do
not use the helmet and contact authorized JUST 1 Helmets personnel only.
Put the cheek pads back into position (refer to paragraph CHEEK PADS).
j U S T O N E H E L m E T S . C O m
USER'S INSTRUCTIONS
EN
5.A
5.B
5.C
29