KNOVA KN 8316 Manual De Instrucciones página 7

Area
• Press the READ key again will toggle back and forth between the length and
width measurement on the upper portion of the screen;
• Press MODE key to clear and begin new area measurement and computation;
• Press MODE key again to select new measurement mode.
Tips:
Press the MODE key one by one will toggle back and forth between the length,
area, volume and length measurement. If there is datum on the display before
pressing MODE key, first pressing the MODE key will clear the current datum, and
the measurement mode will be invariable.
Addition of area under area mode:
• Keep pressing MODE key for 2 seconds to store
the calculated area of first time measurement, at
the same time, the "M+" icon will display on the
screen;
• Press MODE key to clear current data and begin
the second time area measurement and
computation (follow step 1 and step 2 under
the area section);
• After getting the desired area of the second time
computation, press
"+"
mode. A icon will display on LCD.
• Keep pressing the
the first calculated area for the addition.
The "M+" icon will disappear and the stored
memory will be automatically cleared;
+/=
• Press key, the sum of both areas is shown
on the bottom;
• Repeat the steps above to keep adding
the measured area.
+/=
to enter the addition
+/=
key for 2 seconds to recall