Allen + Roth LWS0547G Manual Del Usuario página 4

ASSEMBLY INSTRUCTIONS
1. Secure the crossbar assembly (A) to the outlet
box (not included) with outlet box screws (BB).
Tighten until snug.
Note: The preassembled mounting nipple on the
crossbar should protrude outward.
Hardware Used
Outlet
BB
Box
Screw
2. Remove the preassembled canopy lock ring from
crossbar assembly (A). Temporarily attach the
canopy (D) to the preassembled nipple on the
crossbar assembly (A), securing with canopy lock
ring. If the canopy (D) is not snug against the
ceiling, remove it from the crossbar assembly (A)
and adjust the length of the preassembled nipple by
unscrewing the preassembled hex nut. Screw the
nipple in or out of the crossbar until the correct
length is achieved, then re-attach the canopy (D).
3. Adjust the fixture chain (B) to the desired length,
removing links if needed. Connect one end of the
fixture chain (B) to the canopy chain loop
preassembled to crossbar assembly (A) with one
quick link (C) and then connect the other end of the
fixture chain (B) to the fixture loop preassembled on
the fixture assembly (E) with another quick link (C).
Note: You may need to use pliers (not included) to
open the links of fixture chain (B). If so, put a cloth
over the fixture chain (B) to protect the finish from
the pliers.
1
x 2
2
3
4
Outlet Box
A
BB
Hex Nut
Canopy Chain
Loop
Canopy
Lock Ring
Canopy Chain
Loop
C
B
C
Fixture Loop
E
Lowes.com/allenandroth
Outlet
I
Box
D