Introduction - Dyna-Glo OHIR18LV Instrucciones De Funcionamiento

1. EQUIPMENT
This heater does not require an external electrical
source for operation.
The major components of the heater and a typical
installation are identified in Figure 1. The basic
heater consists of the complete burner assembly, flue
deflector, grid, reflector assembly and face guard.
GAS CONTROL
VALVE
Installation of this appliance at altitudes above 2,000 ft (610 m) shall be in accordance with local codes, or
in the absence of local codes, the National Fuel Gas Code, ANSI Z223.1/NFPA 54 or National Standard of
Canada, Natural Gas and Propane Installation Code, CSA B149.1.
GAS FIRED INFRA-RED WORKSHOP HEATER
PIEZO
IGNITER
THERMOSTAT
CABLE
THERMOSTAT
Figure 1. Heater Major Components
2. PURPOSE OF EQUIPMENT
WARNINGS
This heater is for indoor installation only.
This heater is designed to heat indoor
areas. Do not use for inhabited or small,
enclosed areas.
WALL MOUNTING
BRACKET
BASIC HEATER
EXHAUST
VENT
3