Hunter Energy Star 82033 Guia De Instalacion página 11

C7
C8
Insert mounting screws, leaving space between the screw Attach the rails onto the screws.
head and the joist. (Screws are supplied.)
C9 C10
3"
Run the power supply wire through the strain relief, leaving
Tighten screws.
3" between the end of the wire and the strain relief. Tighten
the strain relief around the wire.
C11 C12
Install the wiring and the strain relief into the wiring access
Connect 6" duct and vent to the outside. Use duct tape to
hole you made earlier.
secure joints. If ducting does not fit securely, an adapter
may need to be purchased.
11
43044-01 03/05/2008