Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Section E - Final Installation
E2
E1
Ground
Green
A
Bare Copper
A
A
Black
White
Connect the wiring as shown.
Install the wiring cover box. Make sure all wiring connec-
tions are inside the wiring cover box.
NOTE: Though this final installation section shows the housing mounted to a joist, the final installation procedure is the same
whether the housing is mounted to a joist or suspended between joists.
E4
E3
Install the fan assembly by inserting the tabs as shown and
Connect fan wiring harness. DO NOT ALLOW THE FAN TO
pushing the fan assembly into the housing. Make certain
HANG FROM THE WIRING HARNESS.
the wiring is not pinched between the fan assembly and the
housing.
E5
E6
Secure the fan assembly by tightening the two fan mounting
Install the strain relief bracket.
screws.
14
43044-01 03/05/2008
Publicidad
Tabla de contenido
