Instructions For Use - BLACK SYSTEM 3010 DGT Manual Del Usuario

INSTRUCTIONS FOR USE

!
Check that the power supply voltage is the same as that shown on the label at
the back of the appliance.
CONNECTION TO POWER SUPPLY
• Check that the on/off switch (1) of the
• Insert the power lead (2) into the socket underneath the lamp and plug into the mains
• To switch on, switch the on/off switch (1) to the 1 position. The
will be placed in stand-by mode: the LEDs will light up in a circle. A program can now be set.
AUTOMATIC SETTING OF THE
• Select one of the 10 automatic programs (4)
• Press START (5) to begin operation
• At any time during operation it is possible to increase or decrease the temperature of the 5
lamps (9), the operating time (7) and the amount of ventilation (11)
• At the end of the program the
begin to cool the lamps. This operation lasts 20 seconds. After this time it will return to stand-
by mode: the LEDs will light up in a circle. It is now possible to set another program.
Automatic programs data
Program
Light Perm
Strong Perm
Care and Treatment
Peroxide dyeing
Tone-on-tone dyeing
Direct dyeing
Bleaching
Streaks
Delicate drying
Strong drying
BLACK SYSTEM 3010 DGT
BLACK SYSTEM 3010 DGT
BLACK SYSTEM 3010 DGT
Duration (minutes)
15
5
8
18
8
12
15
17
40
30
15
is in the 0 position
BLACK SYSTEM 3010 DGT
will beep and will automatically
Temperature (°C)
70
70
70
60
60
60
60
60
70
70
Ventilation
no
no
no
no
no
no
no
no
2
3
GB