Hyundai D255 Manual Del Usario página 17

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

charging. Any disposal of the phone or battery must comply with
laws and regulations pertaining to lithium-ion or lithium-ion
polymer batteries.
Faulty and damaged products: Do not attempt to disassemble
the phone or its accessory. Only qualified personnel must
service or repair the phone or its accessory. If your phone or its
accessory has been submerged in water, Punctured, or
subjected to a severe fall, do not use it until you have taken it to
be checked at an authorized service center.
Specific Absorption Rate (SAR) certification information
Your device conforms to U.S. Federal Communications
Commission (FCC) standards that limit human exposure to radio
frequency (RF) energy emitted by radio and telecommunications
equipment. These standards prevent the sale of mobile devices
that exceed a maximum exposure level (known as the Specific
Absorption Rate, or SAR) of 1.6W/kg. SAR information on this
and other model devices can be accessed online on the FCC's
website through transition.fcc.gov/oet/rfsafety/sar.html.
In normal use, the actual SAR is likely to be much lower, as the
device has been designed to emit only the RF energy necessary
to transmit a signal to the nearest base station. By automatically
emitting lower levels when possible, your device reduces your
overall exposure to RF energy.
The FCC has granted an Equipment Authorization for this model
device based on the compliance of all reported SAR levels with
the FCC RF exposure guidelines. This device has a FCC ID
number : RQQHLT-FS18201 [ Model Number : D255 ] and the
specific SAR levels for this device can be found at the following
FCC website : www.fcc.gov/oet/ea/.
This device was tested simulation typical 10mm to body. To
maintain compliance with FCC RF exposure requirements, use
accessories should maintain a separation distance between the
user' s bodies mentioned above. The use of belt clips, holsters
and similar accessories should not contain metallic components
in its assembly; the use of accessories that do not satisfy these
requirements may not comply with FCC RF exposure requirements,
and should be avoided.
15

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido