Lutron PALLADIOM LMR-C-R Guia De Instalacion

INTRODUCTION:
This guide is intended only for factory trained and equipped
installers of Lutron's PALLADIOM Shades. The following
instructions describe the removal of the Electronic Drive Unit
(EDU) from an existing roller shade, and installation of that
EDU in the Replacement Roller.
For this, the existing shade must be disengaged from its
mounted brackets and disconnected from its wiring. After
the EDU is installed in the Replacement Roller, the converted
shade must be re-connected and secured in the brackets.
Limits should then be verifi ed or adjusted as needed.
For detailed shade removal and re-installation instructions,
please refer to the PALLADIOM Shading System Chassis
Installation & Setup Guide.
COMPONENTS:
Replacement Roller
pre-assembled tube, idler (with spring
if applicable), fabric, and bottom bar;
regular-roll / left-drive shown
Rubber EDU Puck
use only when required;
refer to step 2D on page 2
TOOLS NEEDED:
Power Tool
with #2 Phillips
Driver Bit
04/2019
P/N 045694 Rev. A
Replacement Roller
LMR-C-R
1
REMOVE THE EDU FROM THE EXISTING SHADE:
Expose the Shade Tube
NOTE: For shades wider than 48 in (1219 mm), the
following steps should be performed by 2 people.
A. After removing the existing shade from its brackets, lay
it on a clean, level surface in a location where there is
enough space to unroll the fabric and remove the EDU.
B. Carefully unroll the fabric from the Shade Tube while
loosely wrapping it around the Bottom Bar. Continue
until the Shade Tube is exposed.
Idler End
Remove the EDU
C. EDU Puck Screws: Some shade tubes will have (2)
EDU Puck screws 16 in (406 mm) from the drive end
as shown below. If your shade tube has screws in this
area, remove them and set the screws aside to be
reinstalled in Section 2. If your shade tube does not
have these screws, proceed directly to Step D.
Flat-blade
Screwdriver
Drive End
! CAUTION: RISK OF FALLING OBJECTS. Read and follow all instructions for installing the
Replacement Roller. Failure to follow these instructions could result in minor to moderate injury.
Bottom Bar
(style varies)
16 in (406 mm)
EDU Puck
Screws
Remove the EDU (continued)
D. Insert tip of the fl at-blade screwdriver between the end
of the Shade Tube and the EDU Bearing Sleeve, then
carefully twist and pry to separate.
Bearing Sleeve
Shade Tube
E. With the Bearing Sleeve disengaged from the Shade
Tube, slide the EDU all the way out of the tube.
EDU
F. Set the EDU aside for installation in the Replacement
Roller, and clear the rest of the original shade from the
work area to make room for the next step.
G. Proceed to section 2 on the next page.
O Lutron and PALLADIOM are trademarks of Lutron Electronics Co., Inc., registered in the U.S. and other countries
Lutron Electronics Co., Inc. 7200 Suter Road, Coopersburg, PA 18036-1299, U.S.A.