Publicidad
Enlaces rápidos
Frequency below 433 MHZ is forbidden in Europe, They are just allowed in countries where they are authorized, any
handling and used of these is buyer responsibility.
With compliance with DIRECTIVE 1999/05/CE
MANUFACTURED BY /FAB: ESB06450563
ATTENTION: IN TX NEWCLONER (MULTICLONER) YOU CAN PUT A
FREQUENCY
ENTERING DIRECTLY THE RECEIVER MODE
PROGRAMMING INSTRUCTIONS
1. Locate the selector switch in the inside of the remote. Lever to
separe the case using the tab on the in lower side of the remote.
2. Set your selector switch for the desired brand. Table 1.
3. The remote is ready to be used, press any button (from 1 to 4)
please refer to your receiver's user manual.
Note: To programe BFT, MUTANCODE and ERREKA it will be necessary
to press the hidden button (with a clip) before pressing one ordinary
button (button 1 to 4).
TX NEW CLONER
MANUAL TX NEWCLONER
HIDDEN
BUTTON
ATTENTION, THIS REMOTE WORKS IN TWO DIFFERENT WAYS:
1. ENTERING DIRECTLY THE RECEIVER
2. CLONING
IN EACH BUTTON (CHANNEL) ONLY IN
TECHNICAL FEATURES
ü Model TX NEWCLONER
ü 1 battery 2032(3V)
ü Frecuencies433,92 TO 900 MHz
ü 4 Channels
ü Special chip
ü Software New Cloner patented
DIFFERENT BRAND AND
CLONE MODE
.
Publicidad
Manuales relacionados para Daspi TX NEWCLONER
Resumen de contenidos para Daspi TX NEWCLONER
- Página 1 ATTENTION, THIS REMOTE WORKS IN TWO DIFFERENT WAYS: 1. ENTERING DIRECTLY THE RECEIVER 2. CLONING DIFFERENT BRAND AND ATTENTION: IN TX NEWCLONER (MULTICLONER) YOU CAN PUT A FREQUENCY CLONE MODE IN EACH BUTTON (CHANNEL) ONLY IN ENTERING DIRECTLY THE RECEIVER MODE PROGRAMMING INSTRUCTIONS 1.
-
Página 2: Modo De Entrada Directa En El Receptor
ATENCIÓN, ESTE MANDO TIENE DOS MODOS DE TRABAJO: ENTRADA DIRECTAMENTE EN EL RECEPTOR CLONA MARCA Y UNA FRECUENCIA ATENCIÓN: EN EL TX NEWCLONER (MULTICLONER) SE PUEDE PONER UNA DIFERENTE MODO CLON. EN CADA BOTÓN (CANAL) SOLO EN MODO DE ENTRADA DIRECTA EN EL RECEPTOR INSTRUCCIONES DE PROGRAMACIÓN... - Página 3 ENTERING DIRECTLY THE RECEIVER / ENTRADA DIRECTA EN EL RECEPTOR Table 1: Entering directly the receiver. Tabla 1: Entrar directamente en el receptor. Brand Comments DIP SWITCHES Marca Original Comentarios APRIMATIC Rolling Code 433.92 MHZ APRIMATIC Fixed Code 433.92 MHZ BENINCA TO GO WV / WP Rolling...
- Página 4 ENTERING DIRECTLY THE RECEIVER / ENTRADA DIRECTA EN EL RECEPTOR Rolling CENTURION Code 433.92 MHZ (KING SISTEM) GENIE Rolling GENIE GREEN Code GENIE WOOD MIO TR-2 433.92 MHZ DITEC GOL4 GOL4C Fixed BIXLP2 Code 433.92 MHZ DOORHAN Rolling 433.92 MHZ Code ...
- Página 5 ENTERING DIRECTLY THE RECEIVER / ENTRADA DIRECTA EN EL RECEPTOR FAAC Rolling Red LED XT 433 RC Code LED rojo 433.92 MHZ GIBIDI Rolling DOMINO Code AU1600 433.92 MHZ Fixed TXB-42 Code 433.92 MHZ KINGATE Fixed STYLO4 Code MYO4 C 433.92 MHZ LIFTMASTER Encrypted...
- Página 6 ENTERING DIRECTLY THE RECEIVER / ENTRADA DIRECTA EN EL RECEPTOR Liftmaster Chamberlain Encrypted Motorlift 700 Code Lobas Raynor Orion 433.92 MHZ Marantec Twobi Fixed Raynor Code New England 433.92 mhz Rolling MCT-3 Linear Code 433 MHZ MOTOR Fixed LINE Code 433.92 MHZ MUTAN...
- Página 7 ENTERING DIRECTLY THE RECEIVER / ENTRADA DIRECTA EN EL RECEPTOR NOVOTROM NOVOFERM Rolling TORMATIC Code 433.92 MHZ PRASTEL MPSTF E MPSTP E Fixed TRQ P Code TC E 433.92 MHZ PROTECO PTX433405 Fixed Code 433.92 MHZ PUJOL Rolling VARIO 1 OCEAN Hidden button Code 433.92 MHZ...
- Página 8 ENTERING DIRECTLY THE RECEIVER / ENTRADA DIRECTA EN EL RECEPTOR ROLLTORE OPEN CODE 433.92 MHZ SOMFY 433 Mhz SOMMER Rolling Code 434.4MHZ SOMMER Rolling 868.8 MHZ Code TELCOMA Fixed TANGO Code 433.92 MHz 433.92MHZ 868 MHZ ...
-
Página 9: Clone Mode
CLONE MODE / MODO CLON CLONE MODE PROGRAMMING INSTRUCTIONS 1. Locate the selector switch in the inside of the remote. Lever to separate the case using the tap on the lower side of the remote. Select DIP position brand. Example: Fixed Code. The DIP selector is showed in the picture above. Press button 5 (hidden button) located at the back of CLONER (TX NEW CLONER)remote to active the cloning mode. - Página 10 CLONE MODE / MODO CLON Comments Brand DIP SWITCHES Original Comentarios Marca CLEMSA Mastercode DITEC STANDARD JCM 868 MHz SCAN MODE FAAC Remote scans BOTH FAAC, 433 and 868 Mhz. 433 MHz 868 MHz MODO SCAN mando escanea AMBOS...
- Página 11 CLONE MODE / MODO CLON SCAN MODE Remote scans BOTH V2 433 MHz and 868 Mhz. 868 MHz 433 MHz MODO SCAN mando escanea AMBOS modelos de V2, 433 MHz y 868 SCAN MODE Remote scans ANY fixed code Universal remote.