Transport And Assembly; Maintenance And Disposal - Steelcase Flex Guía Rápida

4. Operation
The product Stand may be used and operated only in perfect technical condition and in compliance with these operating instructions.
Before putting desk utensils or other items on the standing desk, ensure the following:
- Do not exceed the maximum permissible load of the product
The freestanding screen and / or whiteboard can be installed and removed.
Do not overload the hooks on the standing desk excessively.
Please note: Larger objects must not be hooked in as the shift of the centre of gravity may lead to the standing desk falling over.

5. Transport and assembly

Check the delivery contents:
After unpacking, check the product immediately for transport damage and completeness; if applicable, inform the manufacturer as soon as
possible of any damage.

6. Maintenance and disposal

Function check:
Interval Inspection point
Regularly Fastening elements of Flex Stand
-||- Fastening elements of the
markerboard and freestanding screen
-||- End caps on the hooks
Cleaning:
Clean the product regularly with a slightly moist cloth and a mild detergent.

Tip: Lime-deficient water reduces streaks and lime stripes.
Special instructions for linoleum surfaces
Use only neutral cleaners for linoleum surfaces.
■ Especially in the post-oxidation phase, linoleum becomes "yellowish", the drying room yellowing. Yellowing is particularly noticeable in bright
colours but disappears completely and the linoleum regains its original colour when exposed to UV light. Yellowing occurs again when the
surface is covered for a long time with, for example, monitors, mousepads, etc. but disappears as described above as soon as the surface is
exposed to the daylight again.
■ Flowerpots and other pots made of terracotta or clay may leave stains on linoleum; please use suitable coasters.
■ Hand and device disinfectants may cause stains due to their high solvent content.
■ Colouring foods may leave stains that cannot be removed after a prolonged exposure time. Please clean surfaces immediately after soiling.
■ Please do not place wet newspapers on the desk as the ink may dissolve due to moisture.
Linoleum only withstands heat up to 70 °C.
■
143640
Function check
Fastening
Position and attachment
Fixation
Required condition Action (if necessary)
All screws and other
Retighten screws / fix
fastening elements are
fastening elements
tightened / fixed
Markerboard or Re-position and fix
freestanding screen is markerboard or
properly attached to Flex freestanding screen
Stand
End caps are attached to Hooks without end caps can
the hooks be replaced by Steelcase
Service
F l e x
Rev. B