Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
• Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or
relocatable power tap (outlet/power strip).
• There is a resettable cutout switch inside the heater. Should the heater overheat, the cutout will
turn the fireplace heater off. To reset the cutout switch unplug the unit and wait 5 minutes before
plugging it back in. Caution: If you need to continuously reset the cutout, unplug the unit and call
Technical Support.
• Remote control contains a small battery. Keep away from children. If swallowed, seek medical
attention immediately.
Grounding Instructions
• This product is equipped with a cord that has an equipment-grounding conductor and a
grounding plug. The plug must be plugged into an appropriate outlet that is properly installed
and grounded in accordance with all local codes and ordinances.
• This heater is for use on 120 volts. The cord has a plug as shown.
• A 15 Amp, 120 Volt circuit is required. A dedicated circuit is preferred,
but not essential in all cases. A dedicated circuit will be required if,
after installation, the circuit breaker trips or the fuse blows on a
regular basis when the heater is operating. Additional appliances
on the same circuit may exceed the current rating of the circuit breaker.
WARNING:
Electrical outlet wiring must comply with local building codes and other applicable
regulations to reduce the risk of fire, electric shock, or injury to persons.
CARE AND MAINTENANCE
• Clean the metal trim using a water-dampened soft, clean cloth. DO NOT use brass polish or
household cleaners as these products will damage the metal trim.
• The motors used on the fan and the flame generator assembly are pre-lubricated for extended
bearing life and require no further lubrication. However, periodic cleaning/vacuuming of the fan/
heater and air intake/output vents is recommended. The heater should be cleaned and inspected
regularly, depending on conditions, and at least at yearly intervals.
WARNING:
Any electrical repairs of this unit should be carried out by a licensed electrician in
accordance with national and local codes.
WARNING:
Disconnect power by unplugging the power and allowing heater to cool before
attempting any maintenance or cleaning to reduce the risk of fire, electric shock, or injury.
Note:
When the heater is not in use, the heater should be stored in a dry location, away from possible
damage. The power cord should be stored properly to avoid contact with hot or sharp objects.
Remote Control
The battery compartment is located on the back end of the remote control.
1. Press and slide the battery cover open.
2. Insert one 3V (CR2025) battery (included) with the
3. Replace the battery cover.
Note:
The battery should be removed if the product is to be left unused for a long time.
• When replacing the battery, replace with new battery of the correct type.
• Non-rechargeable battery is not to be recharged. Exhausted battery is to be removed from the
product and properly disposed of.
Disposal of Used Batteries
Batteries may contain hazardous substances that could be endangering to environment
and human health.
• This symbol marked on the battery and/or packaging indicates that used batteries shall not be
treated as municipal waste. Instead they shall be left at the appropriate collection point for recycling.
• By ensuring the used batteries are properly disposed of, you will help prevent potential negative
consequences for the environment and human health. The recycling of materials will help to
conserve natural resources.
For more information about collection and recycling of used batteries, please contact your local
municipality, your waste disposal service or the point of sale where you purchased this item.
+
side up into the battery compartment.
Grounding Pin
Publicidad
Tabla de contenido
