Zagg Power Amp 18 Manual De Instrucciones página 3

CHARGING YOUR DEVICES
Your Power Amp 18 carries enough power to charge your phone up to six times*.
Plus, it features three charging outlets that allow for pass-through charging, so you
can charge three devices at once — even with your Power Amp plugged in!
To keep your devices charged:
1. Expose the three charging ports by lifting the protective cover located
on the end opposite the flashlight.
2. Connect the USB end of your charging cable to any of the
Power Amp 18's outlets.
3. Connect the other end of your charging cable to the device you want
to charge — the Power Amp 18 will automatically begin charging it.
4. Continue on your activity until your device is charged to your liking and
then disconnect the charging cable.
5. Recharge your Power Amp 18 as needed.
*Six smartphone charges based on a 1800mAh battery.
CHARGING YOUR POWER AMP 18
Your Power Amp 18 comes charged and ready to go; but here's how to recharge it
when you need to:
1. Expose the micro USB charging port by lifting the protective cover
located on the end opposite the flashlight.
2. Connect the included micro USB charging cable to the micro USB port
on your Power Amp 18.
3. Connect the USB end of the included cable to your preferred 5V USB outlet.
Note: Do not leave your Power Amp 18 plugged into a wall charger for
extended periods of time. Doing so will diminish its long-term performance.
4. The LEDs near the lantern will light according to your Power Amp 18's
current battery level. This indicates your Power Amp 18 is charging.
5. Wait for the battery LEDs to turn off, indicating your Power Amp 18 is
fully charged.
6. Disconnect the charging cable and enjoy 18000mAh of simple,
portable power.