GE AGQ12 Manual Del Propietario E Instrucciones De Instalación página 12

Window Installation Instructions
INSTALL A SUPPORT BRACKET
6
AND THE FOAM TOP WINDOW
GASKET
Attach a support bracket with a Type C
A
screw.
Cut the foam top window gasket to the
B
window width.
Stuff the foam between the glass and the
C
window to prevent air and insects from
getting into the room.
INSTALL THE AIR CONDITIONER
7
IN THE CASE
Slide the air conditioner into the case.
A
Reinstall the 2 screws removed earlier on
each side of the case.
Before installing the front grille, pull out the
B
vent control lever located above the unit
control knobs, as shown.
Attach the front grille to the case by inserting
C
the tabs on the grille into the slots on the
front of the case. Push the grille in until it
snaps into place.
Guide the lever carefully
through the grille as you
push it in.
Lift the inlet grille and secure the front frame
D
with a type A screw through the front grille.
Lower the inlet grille back into place.
Caulk or weather-strip any gaps or openings
to the outside to seal the installation.
12