QuIcK-START INSTRucTIoNS F-SeNSo chucK
1. Switch on the F-senso chuck at the on/off button. The
F-senso chuck may not be clamped in when switched on.
2. Switch on the Tablet
3. establish connection
2
Scan
Name
F-SeNSo chucK
3
cancel
Date: 10.09.2014 Time: 07:56
4. Start measurement
Quick-start measurement
Date: 10.09.2014 Time: 07:56
F-SeNSo chucK 5110004712
1
connect
4
F-senso:
Tablet:
F-SeNSo chucK 5110004712
F-senso:
Tablet:
5. Verify measurement
chuck: std_chuck_3
Name (required)
Top tooling set
Tester
obligatory field
6. clamp in F-senso chuck
6.1 open the clamping device
6.2 Select the measuring bolts such that the clamping positi-
on lies in the middle clamping range.
6.3 clamp the measuring head into the chuck. here, the
clamping bolts must lie in the middle of the clamping jaws. To
avoid measuring errors, it is recommended to use the inserti-
on aid. To do this, push the insertion aid over the clamping
head and let this lie flat on the clamping jaws when inserting
the measuring head.
6.4 Remove the insertion aid
7. The measurement is ended by unclamping the F-senso chuck
again, whereby the clamping force will drop to zero.
The complete operating manual can be found on the Tablet.
F-SeNSo chucK 5110004712
comment
Start measurement