Intended Use; Safety Information - Oase Trafo UST 150/01 Instrucciones De Uso

- GB -
- GB -
Information about these operating instructions
Welcome to OASE Living Water. You made a good choice with the purchase of this product Trafo UST 150/01.
Prior to commissioning the unit, please read the instructions of use carefully and fully familiarise yourself with the unit.
Ensure that all work on and with this unit is only carried out in accordance with these instructions.
Adhere to the safety information for the correct and safe use of the unit.
Keep these instructions in a safe place! Please also hand over the instructions when passing the unit on to a new
owner.

Intended use

Trafo UST 150/01, in the following termed "unit", is designed for the use of 12 V low voltage LED lamps and halogen
lamps (OASE spotlights Lunaqua 10 and Lunaqua 10 LED).

Safety information

The company OASE has built this unit according to the state of the art and the valid safety regulations. Despite the
above, hazards for persons and assets can emanate from this unit if it is used in an improper manner or not in accor-
dance with its intended use, or if the safety instructions are ignored.
The unit is equipped with a loading temperature switch that interrupts the current supply in the event of overload.
Disconnect the mains plug for approx. 1 minute before starting up the unit again.
For safety reasons, children and young persons under 16 years of age as well as persons who cannot reco-
gnise possible danger or who are not familiar with these operating instructions, are not permitted to use the
unit. Keep children under supervision to ensure that they do not play with the unit.
Hazards encountered by the combination of water and electricity
− The combination of water and electricity can lead to death or severe injury from electrocution, if the unit is incorrectly
connected or misused.
− Prior to reaching into the water, always switch off the mains voltage to all units used in the water.
Correct electrical installation
− Electrical installations must meet the national regulations and may only be carried out by a qualified electrician.
− A person is regarded as a qualified electrician, if, due to his/her vocational education, knowledge and experience, he
or she is capable of and authorised to judge and carry out the work commissioned to him/her. This also includes the
recognition of possible hazards and the adherence to the pertinent regional and national standards, rules and regu-
lations.
− For your own safety, please consult a qualified electrician.
− The unit may only be connected when the electrical data of the unit and the power supply coincide. The unit data is
to be found on the unit type plate or on the packaging, or in this manual.
− Ensure that the unit is fused for a rated fault current of max. 30 mA by means of a fault current protection device.
− Extension cables and power distributors (e. g. outlet strips) must be suitable for outdoor use.
− Protect the plug connections from moisture.
4
13389-05-13_GA_Trafo UST 150.pdf4 4 14.05.2013 13:33:07