Ansonic LAT-56 Manual Del Usuario página 13

the "Start/Pause/Cancel" button again.
In this case, "Start/Pause/Cancel" light
will flash and your machine will resume its
program.
Changing the Program
Even if a new program is selected by
changing the position of program selection
knob while your machine is operating, the
first selected program continues to run.
In order to change the washing program,
the ongoing program should be cancelled.
(See. Cancelling a program)
In order to change the auxiliary functions
while your machine is operating, you can
Laundry Addition Function
If you want to add laundry to your machine
after the washing program starts, switch
the machine to pause mode by pressing
"Start/Pause/Cancel" button. If the water
level in the machine is suitable, the "Door"
light on the program follow-up indicator
comes on approximately 2 minutes later
Cancelling a program
In order to cancel the selected program,
"Start/Pause/Cancel" button is pressed
for 3 seconds and machine starts to drain
at the end of this time. After the drainage
process completes "Start/Pause/Can-
cel" lights are off. "Door" light starts to
flash. When the "Door" light is on continu-
ously, the door can be opened and a new
program can be selected. You can start a
program by selecting a new program.
The selected program continues to run
End of the Program
For your safety, your machine will not allow
you to open its door for a while after the
program completes. If you try to open the
door during this period, it will not open and
"Door" led will start flashing. After the door
lock is deactivated, the "Door" and "Fin-
make any desired changes after pressing
the "Start/Pause/Cancel" button.
If you want to change the spin speed
while your machine is operating, press the
"Start/Pause/Cancel" button, select the
spin speed and press the "Start/Pause/
Cancel" button again.
and you can open the door and add
laundry. If the "Door" light is not
continuously on at the end of this period,
the water level in the machine is not
suitable and you can not add laundry.
You can resume the program by pressing
"Start/Pause/Cancel" button again.
even if the position of program selection
knob is changed while your machine is
operating. In order to change the washing
program, a new program can be selected
and started after "Cancelling a program"
by pressing the "Start/Pause/Cancel"
button for 3 seconds as described above.
ished" lamps will light up. You may open
the door in this case.
13
EN