Publicidad
Idiomas disponibles
Idiomas disponibles
1
Attach the CONNECTORS (N) to the POST RAIL (M) with the SCREWS (9) as shown. Attach the CONNECTORS (N) to the
REAR POST 1 (A) and FRONT POST1 (C) with the SCREWS (9) as shown.
Repeat this step using POSTS (B & D) to create two end assemblies.
C
Hardware Required
9
x16
Note: Don't FULLY tighten the screws at this step,
Nota: No apriete COMPLETAMENTE los tornillos en este paso
9 9
N
M
9 9
they shall be fully tightened at the next step
ellos será apretado completamente en el paso siguiente
C
8 /20
NOTE: Warning label on the
post (M) must be at the
same side of the bolt holes
N
on the post (A).
M
A
B34313709605
N
Publicidad
