MOB SP0355 Manual Del Usuario página 3

2. Charging mobile phones and other electronic devices.
a. The portable power device has a USB output port which has the
maximum output current of 2100 mA.
b. Connect to USB cable to your mobile phone/device using the
appropriate connector. Connect the other end of the USB
cable to the OUT port of the portable Power bank. Your mobile
phone/device should display the status as charging.
c. Remove the USB cable from your mobile device when it is fully
charged.
Note: In order to charge device use only accessory cable (provided
with power bank) or the cable included with your
own device by the manufacturer.
IMPORTANT SAFETY PRECAUTION
1. Read all the instructions before using the product.
2. Power bank main unit contains an internal lithium ion battery.
Upon initial use or after a prolonged storage period, fully charge it
once. The unit's full performance is achieved only after 2 or 3
completed charge and discharge cycles.
3. Power banks are not allowed in checked luggage on commercial
airline flights. Handle with care and dispose of in
accordance with local regulations. Carry-on only.
4.To reduce the risk of injury, close supervision is necessary when
the product is used near children.
5. Do not put fingers or hands into the product.
6. Do not expose power bank to rain or water.
WARNING – When using this product, basic precautions should
always be followed, including the following:
7. Use of a power supply or charger not recommended or sold by
power pack manufacturer may result in a risk of fire or
injury to persons.
8. Do not use the power bank in excess of its output rating.
Overload outputs above rating may result in a risk of fire or
injury to persons.
9. Do not use the power bank that is damaged or modified.
Damaged or modified batteries may exhibit unpredictable
behaviour resulting in fire, explosion or risk of injury.
10. Do not disassemble the power bank. Take it to a qualified
service person when service or repair is required. Incorrect