Sunex Tools 8005SC Manual Del Usuario

OPERATING MANUAL
Read and follow all instructions in User's Manual. It is the responsibility of the owner to make sure all personnel
read this manual prior to using the device. It is also the responsibility of the device owner to keep this manual intact
and in a convenient location for all to see and read. If the manual or product labels are lost or not legible, contact
Sunex Tools
read and discussed with the operator in the operator's native language by the purchaser/owner or his designee,
making sure that the operator comprehends its contents.
ASSEMBLY INSTRUCTIONS
Examine box contents, then proceed with following instructions.
Step 1: Slide chrome legs (#2) into square holes cut in tray (#1) until bolt holes are aligned at top of legs.
Step 2: Insert bolt and flat washer into hole on leg and tray. Fasten nut using lock washer and flat washer,
BUT DO NOT TIGHTEN NUT COMPLETELY AT THIS TIME. Repeat this procedure on all four corners.
Step 3: Repeat Step 1 with bottom tray (#1).
Step 4: Repeat Step 2 with bottom tray (#1).
Step 5: Insert casters (#3, #4) into the hole of plastic inserts (#5). NOTE: Insert the two locking casters (#3) at the same end of the cart.
Step 6: Now go back and tighten all loose nuts and bolts (Torque to 60 inch-lbs.).
Step 7: For drawer assembly instructions, if this feature is available with model purchased,
go to Step 8 on reverse side.
Bolt kit for 8005SC cart:
6
9
WARNING
Read and follow all instructions in User's Manual. • Do not load carts
beyond rated capacity 350 lbs. (175 lbs. per shelf) • Lock lid and draw-
ers before moving. • Apply brake on locking casters anytime cart is
in place. • Units can tip or fall causing damage or personal injury.
• Cart is designed to roll easily on flat surfaces and should not be
used on uneven or inclined surfaces. • Do not open more than one
loaded drawer at a time. •Do not stand on or step in drawers. • Keep
children away from unit. • Wear gloves when lifting edges. • This
product may contain one or more chemicals known to the State of
California to cause cancer and birth defects or other reproductive
harm. Wash hands thoroughly after handling. • Failure to heed these
warnings may result in personal injury and/or property damage.
REPLACEMENT PARTS LIST
Item# Part# Description #
1 8007 Tray/each
2 RSSC7 Chrome Leg/each
3 RSSCPLW Locking Caster/each
4 RSSCPW Non-Locking Casters/each
5 RSSCPP1 Set of 4 Plastic Inserts
RSSCPHK Bolt Kit (Incl. 8 each of #6, 7, 8 and 16 each of #9)
8005SC
for replacements. If the operator is not fluent in English, the product and safety instructions shall be
®
8 7
9 9
9 9
6
6
2
8 8
9 9
9 9
6
5
6
3
Req.
Also Available:
2
8006RB
2
RSRBSLIDEC2
2
RS8006HDL
2
RS8006LK
1
RSDECAL01
1
1
MODEL 8005SC
SERVICE CART
9 9
9 9
8 8
8 8
7
7
7
8 8
8 9
9 9
9 9
8 8
7
7
8 8
9 9
7
9 9
10
5
3
Locking Drawer with Roller Bearing Slides
Clip-on Roller Bearing Slides/pr.
Chrome Drawer Handle
Drawer Lock with Two Keys
Black logo decal (not shown)
6
1
6
7
8 9
9
9 9
2
6
9 9
9 9
6
7
8 8
5
4
Rev. 07/29/14