ASROCK K7S41 Manual Del Usuario página 13

Primary IDE Connector (Blue)
(39-pin IDE1, see p.2/p.3 No. 8)
connect the blue end
to the motherboard
80-conductor, ATA 66/100/133 cable
Note: If you use only one IDE device on this motherboard, please set the IDE
device as "Master". Please refer to the instruction of your IDE device vendor
for the details. Besides, to optimize compatibility and performance, please
connect your hard disk drive to the primary IDE connector (IDE1, blue) and
CD-ROM to the secondary IDE connector (IDE2, black).
USB 2.0 Connector
(9-pin USB45)
(see p.2/p.3 No. 18)
Infrared Module Connector
(5-pin IR1)
(see p.2/p.3 No. 19)
Internal Audio Connectors
(4-pin CD1, 4-pin AUX1)
(CD1: see p.2/p.3 No. 28)
(AUX1: see p.2/p.3 No. 29)
Front Panel Audio Connector
(9-pin AUDIO1)
(see p.2/p.3 No. 25)
ASRock K7S41 / K7S41GX Motherboard
Secondary IDE Connector (Black)
(39-pin IDE2, see p.2/p.3 No. 7)
connect the black end
to the IDE devices
There are 4 default USB 2.0
ports on the rear panel. If the
rear USB ports are not sufficient,
this USB 2.0 connector is
available to support 2 additional
USB 2.0 ports.
This connector supports an
optional wireless transmitting
and receiving infrared module.
These connectors allow you to
AUX1
receive stereo audio input from
sound sources such as a CD-
ROM, DVD-ROM, TV tuner card,
CD1
or MPEG card.
This is an interface for front panel
audio cable that allows conve-
nient connection and control of
audio devices.
1 3 1 3 1 3
1 3 1 3