Startup - Honeywell Hometronic HCI 300E Montaje Y Funcionamiento

Interface de transmisión vocal y por internet
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Startup

The HCI 300E can only be used via a telephone with DTMF
dialing*.
To start up the HCI 300E, you must remove the front cover (see
"Installing Hometronic Voice & Web Interface" on Page 52).
Connect the HCI 300E to the voltage supply by plugging the power
supply into an electrical outlet.
Both LEDs on the HCI 300E go on and off repeatedly. Both LEDs
go out after a short time.
If one of the LEDs does not go out, the cabling is not correct
(see "Connecting Hometronic Voice & Web Interface" on
Page 53).
Pick up the receiver of the telephone attached to the connection jack
of the HCI 300E.
A dial tone can be heard.
If a dial tone cannot be heard, the cabling is not correct (see
"Help with problems" on Page 80).
Perform binding.
Startup
57

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido