Positioning Yourself To Work; Disconnecting From The Pole; Dry And Wet Poles; Pole With Conduit - Klein Tools PoleMaster FPD-5295 Instrucciones De Uso, Cuidado Y Mantenimiento

17 Position yourself to work
1. Stop when you are in your desired position to work and
remove your grasp from the cam sub-assembly and carabiner
sub-assembly.
2. Adjust your hips so they are square to the pole.
3. The Wood Pole Fall Restrict Device (WPFRD) functions best
when positioned at or above the users waist as shown.
Conduit at 6 o'clock position.
When climbing a pole that has conduit, one position for the location of the conduit should be directly in front of the end user. The other
position for the conduit location is directly behind the pole. The conduit in relation to the user must either be at 6 o'clock or 12 o'clock
when viewing the pole as a clock face.
Wrong position for cam bracket sub-assembly.
The Wood Pole Fall Restrict Device (WPFRD) hardware must NOT be located on the conduit as shown in photos above.
Hardware must be in direct contact with the pole at the 9 and 3 o'clock positions. Failure to do so could prevent the
Wood Pole Fall Restrict Device (WPFRD) from stopping your fall causing injury or death.
8
18 Disconnecting the wood pole fall restrict device (WPFRD) from
around the pole.
1. Lean toward the pole to add slack from Wood Pole Fall
Restrict Device (WPFRD).
2. With left hand grab the outer strap near the D-ring.
3. Grasp carabiner assembly with right hand and undo
carabiner gate.
4. Disconnect outer strap D-ring from carabiner.
The Wood Pole Fall Restrict Device (WPFRD) has been designed
to meet CSA Z259.14-01 standard as a Type A Fall Restrict Device.
Do NOT use on icy poles.

7. POLE WITH CONDUIT

Conduit at 12 o'clock position.
Wrong position for carabiner sub-assembly.

6. DRY AND WET POLES