Fellowes Lotus RT Sit-Stand Workstation Manual De Instrucciones página 3

STEP 1C
Unbox and determine sitting home position
• Use 2 people to lift the Base and Worksurface (6) out of the box
• Slide the Base and Worksurface (6) onto the table
• Determine your desired sitting home position
Note: If your desired sitting position is in the center of the table, choose a starting position that is offset from the center (image D)
A B
STEP 2
Clamp
• Insert two M8 screws (L) into the Clamp
• Place the Clamp Support Plate (H) on top of the M8 screws (L).
Ensure the tip of the screws align to the holes on the Clamp
Support Plate (H)
• Tighten the M8 screws (L) with the 6mm Allen Key (J) until the
Clamp Support Plate (H) is secured to the desk
STEP 3
Raise sit-stand
• Remove the zip tie from the lever on the right side of the platform
• Engage the lever and raise the sit-stand
• (Optional) If you'd like the lever on the left side of the platform, remove the (2) M6x10mm bolts holding the handle with the 4mm Allen Key (K).
Re-attach to the left side
A
4
Lotus_RT_Manual_872443_RevB_10L_052918.indd 4-5
C D
A B
H
J/L
J/L
B
K
STEP 4A
Attach Monitor Arm
• Install Monitor Pole (2) by placing into cutout on platform and inserting M10 screw (D) with lock washer (A) through the underside of the platform
• Tighten the M10 screw (D) using 8mm Hex L-Key (E)
• Engage the lever and lower the worksurface to the desk
A
STEP 4B
Attach Monitor Arm
• Attach the Fitting (4) to the Monitor Pole and tighten using a Phillips screw driver when at the desired height (image A)
• Slide the VESA assembly onto the Monitor Pole (2) and tighten using the knob on the rear (images B/C)
• Insert cap onto top of pole and secure using M4 screw (B) and 4mm Allen Key (C)
3
A B
2
Single Monitor Arm
STEP 5
Attach Monitor(s)
• Attach your monitor(s) to the VESA assembly using the included Phillips Pan Head
Screws M5x12mm (F) or M4x 12mm (G), depending on your monitor
B
A/D/E
1/B/C
C
3
2
Dual Monitor Arm
F/G
5/29/18 1:10 PM
5