Network Connection; Initial Setup - Nevir NVR-9002-32RD2S-SM Manual De Instrucciones

Chapter 2

Network Connection

To access the Internet, you must subscribe to high speed broadband Internet service with your Internet service
provider (ISP).
Your TV can be connected to your home network in two ways:
• Wired, using the RJ45 (LAN) connector on the back panel.
• Wireless, using the internal wireless and your home wireless network.
Note: Instructions below are just the usual ways to connect your TV to the wired or wireless network. The connection
method may be different depending on your actual network configuration. If you have any questions about your home
network, please refer to your ISP.
Connecting to a wired network
To connect to a wired network:
1. Ensure you have:
• An Ethernet cable long enough to reach your TV
• A router or modem with an available Ethernet port
• A high-speed Internet connection
• An Ethernet (LAN) port on the back of the TV
2. Connect your Ethernet cable to the router and to the
Ethernet port on the back of the TV.
3. Use the Network menu to configure the TV.
Connecting to a wireless network
To connect to a wired network:
1. Ensure you have:
• A router broadcasting a high-speed wireless signal
• A high-speed Internet connection
2. Use the Network menu to configure the TV.

Initial Setup

The first time you switch the TV set on, the Initial Setup appears, which guides you through the initial setup process.
Follow the on-screen instructions to finish the initial setup process such as selecting the language, scanning
channels and more. During each step, either make a choice or skip the step. If you skip a step, you can perform the
setup later from the settings menu.
General Operation
Router
or
Ethernet
Port on
the back
panel
Modem
8
Modem Internet
TV Set
TV Set
Wireless Router
Built-in wireless
connection