Troubleshooting - Black and Decker BDUSB20 Manual De Instrucciones

USB POWER PORTS
The BDUSB20 USB power source is equipped with two USB Type A power ports (2). The
BDUSB20 USB power source delivers 1.5 amps total current.
NOTE: Do not plug in devices that exceed the output ratings on the power source's
label. Doing so will shorten the power source's useful life.
• Install battery into BDUSB20 USB power source (1).
• Insert a USB plug into one of the power ports (2) to supply power or charge your
device.
Problem
• Unit will not supply
power.
• Battery pack will not charge. • Battery pack not inserted into charger. • Insert battery pack into
• Unit shuts off abruptly.
For assistance with your product, visit our website at www.portercable.com for a list of
service centers, or call the BLACK+DECKER Customer Care Center at (888) 848-5175.
The RBRC™ Seal
The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the
Li-Ion battery (or battery pack) indicates that the costs to recycle the battery
(or battery pack) at the end of its useful life have already been paid by
BLACK+DECKER. RBRC™ in cooperation with BLACK+DECKER and other
battery users, has established programs in the United States to facilitate the
collection of spent Li-Ion batteries. Help protect our environment and conserve natural
resources by returning the spent Li-Ion battery to an authorized BLACK+DECKER
service center or to your local retailer for recycling. You may also contact your local
recycling center for information on where to drop off the spent battery.
RBRC™ is a registered trademark of the Rechargeable Battery Recycling Corporation.
MAINTENANCE
Cleaning
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.

TROUBLESHOOTING

Possible Cause
• Battery pack not installed properly.
• Battery pack not charged.
• USB plug not inserted fully.
• Charger not plugged in.
• Surrounding air temperature
too hot or too cold.
• Battery pack has reached its
maximum thermal limit.
• Out of charge. ( To
maximize the life of the
battery pack it is designed
to shutoff abruptly when
the charge is depleted.)
7
Possible Solution
• Check battery pack
installation.
• Check battery pack
charging requirements.
• Check if USB plug is fully
inserted into power supply.
charger until LED
lights.
• Plug charger into a
working outlet. Refer to
"Important Charging Notes"
for more details.
• Move charger and battery
pack to a surrounding air
temperature of above 40
degrees F (4,5°C) or below
105 degrees F (+40,5°C).
• Allow battery pack to cool
down.
• Place on charger and
allow to charge.