Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
• Only groups A,B or C which are in M or TTL mode will be
adjusted
• Both "Manual" and "TTL" modes can be adjusted
simultaneously by one relevant increment. (i.e. one
increment of manual power may be more than one
increment of TTL FEC compensation)
Multi : Stroboscopic Flash
With stroboscopic flash, a rapid series of flashes are fired.
It can be used to capture multiple images of a moving
subject in a single photo. You can set the firing frequency
25
(number of flashes per second expressed in Hz), the
number of flashes
1. Press
A
<MT> mode is displayed
2. Press <SEL>
C
will flash
A
3. Press
flash will flash
•
Turn <Adjust Dial>
•
Press
•
Turn <Adjust Dial>
flashes
C
4. Press
•
Turn <Adjust Dial>
•
In <MT> mode the max power level 1/4
5. Then press button <SEL>
Pressing button
group
Pressing button
"MULTI MODE" and return to standard Manual/TTL /OFF
setting
• For "Nikon" version the RPT repeating flash mode is
only available when used with the hahnel Modus 600RT
Speedlight. Check our website www.hahnel.ie for future
firmware updates which may enable this feature when using
the Nikon Viper TTL receiver with original Speedlight's.
High Speed Sync
Press and hold button
the icon
20
groups at the same time.
• For "Nikon" version ensure also that the camera setting is
set to 1/320's (Auto FP) or 1/320's (Auto FP). Both Viper
transmitter and Camera menu must be set to HSS. Refer
to camera manual for more info.
6
24
, and the flash output
button for more than 3 seconds so that
02
button and all icons for
button to select <T> the number of times the
B
to select "Hz" the flash frequency
to select the flash output level
A
or
B
or
A
for more than 3 seconds will exit
B
will switch on. High speed sync applies to all
03
to set the number of flashes
03
to adjust the frequency of
03
to adjust the output power
02
to save the setting
C
will turn ON/OFF each
to switch on high speed sync -
26
A
,
B
and
Viper TTL - English
Publicidad
Tabla de contenido
