your devices
•
A - Turn off both Viper TTL transmitter and receiver
•
B - Hold down <Test> button
"transmitter". LED
button and LCD
•
C - Now hold down receiver <Test> button
turn ON
rapidly. Release <Test> button
change to red ON all the time confirming DCM is
completed
•
D - If you have additional Viper TTL receivers, then
repeat stage "C". (Viper TTL transmitter must still be in
"coding")
• If you are using the Viper TTL in combination with the
hähnel Modus 600RT Speedlight, you can still DCM all
devices. Use the same procedure from A to D and then
also DCM match the Modus 600RT as a slave version as
explained in Modus manual
• It is possible to reset the Viper TTL transmitter and
receiver to "open channel"
• Hold down <Test> button
and continue to hold down button
06
LED
Transmitter is now "open channel"
• Now hold down receiver <Test> button
receiver and continue to hold down button
than 5 sec. LED
always ON. Receiver is now "open channel"
• If you wish to use old 3rd party Speedlight's which are not
E-TTL or i-TTL compatible, then set switch
"C" whilst performing the reset of the Receiver to "open
channel". This allows 3rd party Speedlight's to be triggered
in Speedlight "M" mode. Check our website www.hahnel.
ie for more info
Multiple Receivers & Flash Guns
•
Additional Viper TTL receivers (i.e. Speedlights) can
be triggered wirelessly from the Viper TTL transmitter.
These additional receivers are available as an
accessory
Software Upgrade
•
The micro USB socket
update the Viper TTL firmware if necessary. Go to
our website www.hahnel.ie for information on how to
download and update the firmware
8
06
will flash rapidly, release the test
05
will display "coding"
12
"receiver". The LED
will change from rapid flashing to always ON.
11
will change from rapid flashing to
08
and turn ON
11
will flash green
15
. The LED
08
and turn ON transmitter
08
for more than 5 sec.
15
09
13
and
can be used to
15
and
06
will
and turn ON
15
for more
16
to Group
Viper TTL - English