GE Winterberry Instrucciones Para El Ensamblaje

Winterberry
Assembly Instructions
CAUTION: EXERCISE CARE WHEN UNPACKING AND ASSEMBLING
Nicolas Holiday Inc. thanks you for purchasing this pre-lit Christmas tree.
Should you have any problems with your tree, visit us at
www.geholidaylighting.com
You can call our toll free number at 1-877-398-7337.
Check our website for latest service hours and assembly instruction videos.
WARNING:
Risk of fire and electric shock. Disconnect light set from power before starting.
1) Keep wires clear of being pinched or cut during assembly or installation.
2) Do not press or grasp bulbs during assembly or installation.
3) Before starting make sure stakes are clear of underground:
sprinkler, telephone and power lines.
4) Please read all instructions and warnings included with this product before using.
1. Carefully unpack, removing any bubble wrap and inspect the
contents of your tree. {Fig. A}
A
Top section
Bottom section
Spare parts bag with instruction manual
B
90
The tree stand should be open and set at 90 angle. Remember to tighten
the thumbscrew after connecting bottom section and tree stand. See {Fig. B}
Untie red twist-tie to release branch panels.
Gently position any branches that do not fall into place.
Your assembled tree may be heavy and difficult
to move when done, so place the stand in desired
location before assembling.
Secure in place using the (4) metal stakes.
2. When you connect two tree sections, it is
important that you align square shape pin type
connector. See {Fig. C}
Assemble section by section.
Disconnect the decorative item from the power source before
performing any maintenance or cleaning.
Indoor/ Outdoor
THIS IS NOT A TOY, FOR DECORATIVE USE ONLY.
GE is a trademark of General Electric Company
and is under license by Nicolas Holiday Inc.
Distributed by Nicolas Holiday Inc.,
©2019 Nicolas Holiday Inc.,9 F., No. 37, Guangfu North Rd.
Taipei, Taiwan 10560 All rights reserved.
120V Printed in China
8.25"x11.25"
Branch Tree
®
for more information.
Metal stand and 4 stakes
Thumbscrew
C
5WBT-LO19
TREE ASSEMBLY DIAGRAM
Top
section
Bottom
section
3. Electrically connect by fully inserting the plug from the top pole into
the end connector near the top of the bottom pole.
4. To illuminate, find and unhank the long lead wire from the bottom
lighted section.
Fully insert the plug directly into a working GFCI outlet
or an outdoor rated extension cord.
NOTE: Hammer/Mallet may be required for stakes
Tree Sections Tree Stand
5 ft tree 2 Metal
Troubleshooting Tips
If one section of your tree does not illuminate, check that section for loose
or missing bulbs or that all electrical connections on tree are made.
Also, check the fused plug for a missing or burned out (open) fuse and
make certain the wall switch is turned on.
IMPORTANT: Store your carton neatly in a cool, dry location protected
from sunlight to prolong the tree life and to better keep the light sets in
working order. Do not place a heavy load on the carton to avoid damage
to or crushing the carton and tree inside.
SPARE PARTS: Your tree includes spare bulbs, replaceable fused bulbs and
spare 3-amp fuses as replacements for the lighting strings.
5FT
Approx. Asm Time
20 minutes