Utilitech PHB-1500 Manual Del Usuario página 4

ASSEMBLY INSTRUCTIONS - FREESTANDING
1. Attach the top tube (F), the connecting tube (B) and two bottom tubes (D) to one of the support
tubes (A) with four M6x30 screws (AA). Tighten the screws using the hexagonal screwdriver (DD).
Hardware Used
AA
M6x30 Screws x4
1
2. Turn over the assembly from Step 1. Slide the rubber connector (E) to the middle of the top tube (F).
Insert the long side of the handle tube (G) into the rubber connector, then secure the short side of the
handle tube (G) to the connecting tube (B), with an M6x30 screw (AA). Tighten the screw using the
hexagonal screwdriver (DD).
Hardware Used
AA
M6x30 Screws x1
2
Lowes.com
6
3. Turn over the assembly again. Secure the long side of handle tube (G) to the top tube (F) with an
M6x30 screw (AA). Tighten the screw using the hexagonal screwdriver (DD).
Hardware Used
AA
M6x30 Screws x1
3
4. Secure the second support tube (A) to two bottom tubes (D), connecting tube (B) and top tube (F)
with four M6x30 screws (AA). Tighten the screws using the hexagonal screwdriver (DD).
Hardware Used
AA M6x30 Screws x4
4
Lowes.com
7