Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 20
8 ChaNgINg The propellerS
If the rotor blades of the multicopter are damaged, they must be replaced.
Proceed as follows:
8A Prior to installation, make sure that you do not mix up the propellers.
The multicopter has 3 different propellers, which differ in colour and direction of
rotation. If the propellers are mixed up, the multicopter will not fly. The two blue
propellers are in front. Please also make sure that the propellers are correctly fit
on the motor shaft. The upper side is bent slightly downwards. A small „A" or „B"
can be found on the underside of the propellers. If the propellers are mixed up,
the copter will not fly.
8B Now carefully pull the propeller off the shaft of the motor.
8C Carefully fit the new propeller on the shaft and carefully screw the securing screw
on again in a clockwise motion.
Front, top, white
Front, bottom, red
Attention:
The side of the propellers with a small, embossed „A" or „B" must face downwards.
Flight direction
The two rotors arranged on top of one another are in front.
20
20
Rear, right, red
Rear, left, white
TroUBleShooTINg
Problem: The propellers do not move.
Cause:
• The ON/OFF switch is in the "OFF" position.
• The battery is too weak or depleted.
Remedy: • Set the ON/OFF switch to the "ON" position.
• Charge the battery.
Problem: The multicopter stops and descends during flight for no apparent
reason.
Cause:
• The battery is too weak.
Remedy: • Charge the battery.
Problem: It isn't possible to control the multicopter using the remote
control.
Cause:
• The ON/OFF switch is in the "OFF" position.
• The batteries were not inserted correctly.
• The batteries do not have enough power.
Remedy: • Set the ON/OFF switch to the "ON" position.
• Check whether the batteries are inserted correctly.
• Insert new batteries.
Problem: The multicopter only turns on its vertical axis or rolls over when
started.
Cause:
• Incorrect arrangement of the propellers.
Remedy: • Install the propellers as outlined in the manual.
Problem: The multicopter won't fly a looping manoeuvre.
Cause:
• Battery too weak.
Remedy: • Charge the battery.
Additional tips and tricks can be found online at www.revell-control.de.

SerVICe NoTeS

Go to www.revell-control.de for ordering information
and tips on replacing spare parts, plus other useful
information on all Revell Control models.
www.revell-control.de
21

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

23958

Tabla de contenido