Urmet BiBus II ED. Manual Del Usuario página 14

Programming door phones in 1st edition systems
using the programming adapter
The door phone programming sequence consists of
two steps:
A. Door phone booking (to be made on a calling
station).
B. Door phone programming (to be made in the
apartments).
A: Door phone booking
1. Insert adapter 1072/60 in the specifi c minidin
connector.
2. Press the user buttons to be associated with
the door phones once. The booking sequence
according to which the buttons are pressed
must be the same as the order in which the
operator will go to the apartments.
3. A beep will be heard after 30 seconds from last
pressing a user button (end of booking).
4. Leave the adapter 1072/60 in the digitiser and
go to the apartments to program the door
phones.
B: Door phone programming
1. Go to the fi rst booked user, hold the button
pressed and lift the door phone handset. Two
confi rmation beeps will be heard and the
LED will fl ash to indicate that it has been
programmed.
2. Go to the other booked users and repeat the
operations.
Refer to the attached sheet to remember the code/
button association sequence.
SEQUENZA DI ASSOCIAZIONE
ASSOCIATION SEQUENCE
N° DELLA POSTAZIONE (ID):
CALL MODULE NUMBER (ID):
SEQ. NOMINATIVO PULSANTE / CODICE
USER NAME PUSHBUTTON / CODE
1
2
3
4
5
The entire operation (booking and programming)
must be repeated for each digitiser in the
system, unless the "Clone" function (see below)
is used.
Associating 2 door phones in parallel in 1st
edition systems using the programming adapter
To install two door phones in one apartment and
make them both ring when a call is received, press
the button related to the user twice with the door
phones in parallel when booking the door phones.
When you reach the apartment where the parallel
door phones are installed according to the
programming sequence, repeat the programming
sequence on both door phones.
14
Adding new users in 1st edition systems using
the programming adapter
Insert the programming adapter in the specifi c
digitiser connector. Press this button to book
programming and go to the user to program the
door phone.
The entire operation (booking and programming)
must be repeated for each digitiser in the
system, unless the "Clone" function (see below)
is used.
Using the "clone" function with the programming
adapter
A single association between calling stations and
respective door phones can be made in 1st edition
systems without switchboard and without door open
signal function.
The remaining calling stations must be clones of the
fi rst station (master) providing the wiring between
push-button panel buttons, calling station terminals
and expansion modules in the "Master" station are
repeated exactly.
To enable this function:
• defi ne the master position as address "1";
• (the position on which to make the association);
• defi ne all other stations as address "F".
SIMPLIFIED PROGRAMMING
The door unit and the door phones can be
programmed without external devices in 2nd edition
systems consisting of main calling stations only
(up to three). The following parameters can be
programmed in this case:
• main station number: with dip-switch (1,2,3);
• lock activation time: with LED button (1-30s);
• door phone programming with LED button
PIANO VARIE
FLOOR VARIOUS
Station number (ID)
The two dip-switches determine the main station
number as shown in the following table:
Dip-switch position Main station number
(predetermined user codes).
Not defined (for programming with
an external keyboard)
Station 1
Station 2
Station 3
DS1072-022A