Troubleshooting - Indicator Lights - Pentair PENTEK PSD25PB Manual De Instalación Y Funcionamiento

Troubleshooting - Indicator Lights

There are four LED lights on the Pentair Pentek* Solar Drive. The indicator lights and their
definitions are listed below.
AC LOAD
(Green)
ON
FLASHING
ON
OFF
OFF
OFF
ON
FLASHING
OFF
FLASHING
OFF Mode
Startup Mode
Running Mode
Standby Mode
Float Switch
Mode
Over Temperature Pentair Pentek Solar Drive stops operation when the temperature
Mode
Power Deration
Mode
Over-current
Mode
Open Circuit
Mode
Dry Well
Protection
P1063 (10-03-19)
SOLAR
(Yellow)
ON
OFF
OFF
FLASHING
OFF
OFF
OFF
OFF
FLASHING
FLASHING
Pentair Pentek Solar Drive toggle switch is in the OFF position.
Pentair Pentek Solar Drive is in the process of starting the motor pump.
Pentair Pentek Solar Drive is running the motor pump.
There is not enough power from the solar PV panels for
Pentair Pentek Solar Drive to start the motor.
Pentair Pentek Solar Drive is turned OFF as a result of input from one
or more external sensors that are connected to the digital input.
inside the unit exceeds 80°C/176˚F.
Pentair Pentek Solar Drive still operates but with reduced power
throughput due to increased operating temperature, or if a load
is connected with current higher than over-current protection
DIP Switches 6 and 7.
Pentair Pentek Solar Drive stops operation when it detects high current
on the motor terminals. This can also be due to a short circuit event if
the unit is mis-wired. Requires manual restart by cycling power to
the unit.
Pentair Pentek Solar Drive will not start operation if the motor wiring
does not align with DIP switch configuration.
Pentair Pentek Solar Drive detects dry well condition, and ceases pump
operation, which is restored after 30 minutes. If dry well indication
appears faulty, check that over-current protection DIP Switches
6 and 7 are configured correctly.
WARNING
(Red)
ON - Unit is OFF
OFF - Startup
OFF - Running
OFF - Standby
FLASHING - Float Switch
ON - Over Temperature
ON - Power Deration
FLASHING - Over-current
FLASHING - Short/Open Circuit
FLASHING - Dry Well Protection
MODE
17