Parts & Assembly - Nostalgia Electrics NBM400 Instrucciones Y Recetas

PARTS & ASSEMBLY
Before first use, wash all parts except Base in warm soapy water with a non-abrasive cloth or
sponge. Dry with a non-abrasive cloth. Wipe Base with a damp cloth and dry. DO NOT place
Base or cord in water.
PARTS
Nut Bin Base
Nut Bin Cover
ASSEMBLY
Place the PEANUT BUTTER MAKER on a dry, level surface near an electrical outlet.
1. Place the Nut Grinder/Chute on top of Base with Chute
resting in the space on the front of the unit.
2. Attach Chute Cap to end of Chute.
3. Place the Nut Bin on top of the Base with Nut Grinder/Chute attached. Gently
force the Nut Bin down until it snaps into place. NOTE: Be sure Nut Bin is
properly affixed to Base or PEANUT BUTTER MAKER will not turn on.
4. Place the Nut Bin Cover on top of Nut Bin. Make sure hole in Cover is aligned
with the Nut Grinder. The hole should be directly above the Nut Grinder.
5. Place Nut Guide in Nut Bin.
6. Insert Oil Dispenser in Nut Guide.
7. Put Nut Butter Container on Base below Chute.
Now you're ready to enjoy fresh nut butter with your PEANUT BUTTER MAKER!
5
Nut Grinder/
Chute
Oil Dispenser
Nut Butter
Container
Lid
Chute Cap
Nut Guide