Draw-Tite 41541 Instrucciones De Instalación

Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: K41541
Wrenches: 14mm, 17mm
Drill Bits: None
Frame Rail
1
Qty. (6) Hex Bolt M10 x 1.25x 30mm CL10.9
1. Remove tow hooks from frame rails and return to vehicle owner.
2. Remove plastic caps in forward attaching holes.
3. Raise hitch into position and install fasteners as shown above.
Tighten all M10 x 1.25 CL10.9 fasteners with torque wrench to 42 Lb.-Ft. (57 N*M) Ti ht ll M10 1 25 CL10 9 f
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent
entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a
vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.
z
2000, 2001, 2009, 2011 Cequent Performance Products
Installation Instructions
Lexus RX300
Toyota Highlander
Fascia
Existing Weldnut
2
t ith t h t 42 Lb Ft (57 N*M)
Sheet 1 of 3
Do Not Exceed Lower of Towing Vehicle
Manufacturer s Rating or Manufacturer's Rating or
Hitch type
Trailer WT (LB)
Weight Distributing
Weight Carrying
3500 (1589 Kg.)
Ball Mount
Wiring Access Location: SUV1, SUV2
Qty. (6) Conical Toothed Washer 3/8"
N41541
Part Numbers:
41541
78229
U-Haul
Max Gross Max Tongue
WT (LB)
Do Not Use With Spring Bars
350 (159 Kg.)
Fasteners Typical
Both Sides
4-8-11 Rev. B
Form: F205 Rev A 5-6-05