General Information - golmar 12095130 PL-GTWIN 230Vca Manual De Instrucciones

GENERAL INFORMATION

Ref. 12095130 device is a varistor protection against overvoltage for power supply line (SPD). In case of overvoltage
generated by atmospheric events, the device operates in order to limit risk of damage to system electric and
electronic equipment.
The led on the upper side of the device indicates that surge protection is working properly.
When the led turns off, the protection must be replaced.
†
The led stays on also in case of mains failure.
Designed and certified according to EN61643-11/A11 European standard.
The device is not subject to FOLLOW CURRENT condition, so in case of maintenance operations there are few
chances of service interruption for the protected device.
It is suggested to add to SPD class III device a mains filter (for ex. Ref. 12095125) for high frequency noise. In this way,
the protection against EMC conducted noise is completed.
For connections to the system, see the manual and the specific safety rules for electric installation.
INSTALLATION
The device must be fixed to a DIN bar in a closed service panel.
WARNING
• The device must be installed by skilled personnel only.
• The system must be compliant with regulations in force. All system devices must be used uniquely for the
purpose for which they were originally designed: any other use is improper. The manufacturer is not responsible
for damages resulting from improper use.
• The device has been designed to be compliant with regulations in force.
• Before powering the device, check that mains voltage conforms with the equipment.
• Unpack the device and check that it is not damaged. In case of damages, do not install it.
• Keep packing parts, which may be a source of danger, out of reach of children.
• Do not install the device in wet locations or near heat sources. Place the device on a dry and solid surface,
protected against rain and bad weather, using its fixing methods.
• Ensure a sufficient ventilation.
• Don't install the device during storms with lightnings.
• Don't touch not insulated cables before disconnecting them from mains.
• Do not tamper or open the device. The warranty will be void if the device is opened or tampered. If necessary,
contact an authorized technical assistance centre.
50123702 DS1382-005
2 DIN modules
ENGLISH
5