golmar 12095130 PL-GTWIN 230Vca Manual De Instrucciones página 6

• The device doesn't contain parts subject to maintenance.
• Before any cleaning or maintenance operations, disconnect the device from mains, by switching the system off.
Do not use spray cleaners.
• In case of device failure and / or malfunction, unpower it using the general switch; do not tamper it.
• For repairing, contact an authorized technical assistance centre only.
• If the above rules are not observed, whole device safety may be compromised.
• This document must always be provided with the device.
WIRINGS
†
The equipment must be protected before its input by a surge protection device against overcurrent (fuse or
automatic switch with 16A capacity).
†
Remove the cable insulation sheath for 8mm max.
†
The distance "d" between the device and the beginning of the line to be protected must be as short as
possible.
Cable type
Nominal section
Terminal pins max. seating torque
DRAFT DIAGRAM
6
L
230V ~ mains
N
d
To the connected
devices
Ref.12095130
L
N
Ground
stranded
2,5÷6 mm
2
5 Nm
solid core
2,5÷6 mm
2
5 Nm
50123702 DS1382-005